WHAT DO YOU KNOW ABOUT INDUCTION LAMP?

INTRODUCTION AND PRINCIPLE OF INDUCTION LAMP

Induction lamp does not have filament, electrode inside, which is lighted by electromagnetic induction instead of the traditional tungsten electrodes. Comparing with the traditional light source, induction lamp is more energy saving, environmentally friendly and longer life. Mainly used in the factory, stadium, shopping mall, station, tunnel, road, floodlight, explosion-proof lighting and other places of high power lighting, induction lamp is the best green industrial lighting product to replace the traditional light source.

Technical principle:

Induction lamp relies on the fundamental principles of electromagnetic induction and gas discharge to emitting UV radiation that in turn is converted into visible white light by the phosphor coating on the bulb.

ADVANTAGES OF INDUCTION LAMP

LONG LIFESPAN

Since there is no filament and electrodes inside, the general life is up to 60,000 ~ 100,000 hours, 50 times of the traditional incandescent light,10 times of the energy-saving lamp 10 times, and 5 times of HID.

HIGH ENERGY EFFICIENCY

Lumen efficiency is up to 90Lm/W, integrated with ELX ballast & lighting fixture, compared with average incandescent , energy saving lamp and traditional HID, respectively saving up to 85%,50%,40%.

ENVIRONMENT FRIENDLY

Amalgam technology will remain in its solid state throughout the life of the tube even if the tube is broken. With 99% coefficient of recovery makes it a real environmental friendly lighting source.

HIGH COLOUR RENDERING

Induction lightings colour rendering index is more than 80%, compared with metal halide lamps and high-pressure sodium lamp, induction lamp restores all kinds of colors for increasing 30% & 4 times.

NO FLICKERING

The working frequency is up to 250 KHZ, which eliminates the flickering harm of traditional HID, daylight tubes and energy-saving lamps, greatly protects people from eye fatigue and myopia caused by flickering.

SOFT LIGHT

Induction lighting is a surface emitting lighting. Large light emitting area, brightness scattered, less glare. We could watch the light source directly with less visual fatigue, avoiding light pollution effectively.

LOW HEAT

Working surface temperature is below 80℃ and low thermal sensitivity would not cause serious light decay, decreased stability or aging of reflector.

LITTLE LUMEN DECAY

2000 hours less than 5%, 20,000 hours less than 15%, much better than the traditional light source.

STABLE WORKING